File:Circle-diamond-square-50mm.txt

From ShapeOko
Jump to: navigation, search
Circle-diamond-square-50mm.txt(file size: 18 KB, MIME type: text/plain)
Warning: This file type may contain malicious code. By executing it, your system may be compromised.

Hand-coded G-code to cut this standard machining test in HDPE using a 1/8" bit @ 355mm/min, w/ 1.5mm stepover and 0.5mm depth advance (the last value is probably too small). Thickness is appropriate to a "half-inch" cutting board. Code leaves the tool at the end of the path and should be homed before shutting down.

Run-time over 1 hour.

File history

Click on a date/time to view the file as it appeared at that time.

Date/TimeDimensionsUserComment
current18:19, 30 March 2013 (18 KB)Willadams (Talk | contribs) (Hand-coded G-code to cut this standard machining test in HDPE using a 1/8" bit @ 355mm/min, w/ 1.5mm stepover and 0.5mm depth advance (the last value is probably too small). Thickness is appropriate to a ``half inch'' cutting board. Code leaves the tool a)

The following page links to this file:

Personal tools
Namespaces
Variants
Actions
About
Additional Build Information
Using Your Machine
Software
Upgrades
Additional Resources
ShapeOko 1 Build Instructions
wiki
Toolbox