Assembly step 10

From ShapeOko
Jump to: navigation, search

These are the instructions for the SO1 and are here for historical reasons only.

If you are building an SO2, please see the instructions at http://docs.shapeoko.com/

(click the picture to download the PDF file)

Spindle Mount Assembly

The typical spindle is a high-speed rotary tool (Dremel™ or clone). There are a number of alternative tools and mount possibilities.

Bill of Material

Sortable table
Item Qty. Part Num. Title Notes
8 8 SM-H03 M5 Flat Washer
15 4 SM-H09 M5 x 55mm SHCS
16 8 SM-H02 3/4" Nylon Spacer
19 4 SM-H07 M5 x 10mm SHCS
21 4 SM-H11 Insertion Nuts
31 2 SM-TM1 Spindle Retainer Mount (see above diagram)
32 2 SM-TM2 Spindle Retainer Strap (see above diagram)
33 1 SM-TM3 Spindle (IEK-17)

User Submitted Notes

(This is the section to add your own notes pertaining to this sub-assembly) If you run into a problem or find yourself asking a question, please post the solution here to help the next person who has the same problem/question)

Required parts
Step10 1.png
Step10 2.png
Step10 4.png

In attaching the spindle retainer mount to the Makerslide I could not get the SM-H07 M5 x 10mm SHCS bolts to bite into the SM-H11 insertion nuts so I had to eliminate the M5 Flat washers.

Step10 5.png


Next: Assembly step 11