Not tapping Makerslide

discussion of design changes / improvements / suggestions

Not tapping Makerslide

Postby JuKu » Fri Sep 06, 2013 5:03 am

FYI: Misumi self-tapping screw HTJ5 is compatible with Makerslide. In other words, this worked for me:

Standard torx25 bit in power screwdriver, held Makerslide firmly. Pressing hard to the tabletop with one hand is enough, I didn't need a vice (but I'm a big guy, YMMV). Screw the bolt as far as it goes, back up, repeat. Second or third time it will go all the way in. Take bolt out, insert plate and washer and screw it back. Done.
JuKu
 
Posts: 69
Joined: Sun Sep 02, 2012 2:55 pm

Re: Not tapping Makerslide

Postby cvoinescu » Fri Sep 06, 2013 8:29 am

Very useful information, thank you! I'll add a few of these to my next Misumi order.
Proud owner of ShapeOko #709, eShapeOko #0, and of store.amberspyglass.co.uk
cvoinescu
 
Posts: 4442
Joined: Thu Jul 19, 2012 6:50 pm
Location: Camberley, UK


Return to Design Ideas

Who is online

Users browsing this forum: No registered users and 1 guest